A 180-degree gate hinge allows the gate to swing fully flat against the fence, clearing the entire opening width. This is useful for driveways where vehicles need full clearance, or commercial entrances where the gate would otherwise block traffic when open.

A standard chain link gate hinge limits the gate swing to about 90 degrees. A 180-degree hinge allows full 180-degree rotation, letting the gate fold back against the fence line completely.

Our 180-degree commercial gate hinges fit gate post outside diameters from 2-3/8 to 8-5/8 inch and gate frame outside diameters of 1-5/8 or 1-7/8 inch. Measure both the post and frame before ordering.

Installation is similar to standard chain link gate hinges using the included U-bolts. Ensure the post is plumb and the gate is level before tightening the hinge to prevent binding at full swing.

Yes, if the post and frame sizes match. The U-bolt installation method is the same as standard hinges, and the gate does not need to be modified to accept a 180-degree hinge.

A 180-degree hinge allows the gate to open fully but does not hold it open against wind. A gate holdback or duckbill latch can be used to prop the gate open in the fully-open position when needed.

Commercial-duty 180-degree hinges are designed for standard to heavy residential and commercial chain link gates. Check the specific product rating for the maximum gate weight and frame size it supports.

Yes. 180-degree hinges can be used on both leaves of a double gate, allowing each leaf to swing fully open for maximum clearance.

No. Chain link gate hinges clamp onto round tubular gate frames and posts. For wood gate hinges that allow full-open swing, use a strap hinge with a long throw or a specialty wide-swing wood gate hinge.

Install one hinge near the top and one near the bottom of the gate frame, keeping the hinges within 12 to 18 inches of the top and bottom of the gate. For taller or heavier gates, add a third hinge in the middle.